The MAXIMATOR gas boosters’ operating principle is similar to a pressure intensifier. A large air piston is charged with low pressure (air piston (3)) and works on a small area with high pressure (hp piston (2)). The continuous operation is achieved by a pilot operated 4/2 way valve (spool (4)). The spool leads the drive air alternately on the upper and bottom surface of the air piston.

The spool is piloted through two 2/2 way valves (pilot valves (7)) which are mechanically actuated through the air piston in its end positions. The pilot valves charge and discharge the spool chamber. The hp piston supported by the check valves (inlet check valve and outlet check valve (1)) delivers the flow.

The outlet pressure is directly related to the set air drive pressure. According to the formulas indicated in the table with technical features of the gas boosters, the static end pressure can be calculated. At this pressure a force balance between drive section and gas section is achieved. The gas booster stalls when this end pressure is reached, and does not consume any further air.

A pressure drop at the high pressure side or a pressure increase at the drive side starts the booster automatically until the force balance is achieved again. Additionally the MAXIMATOR gas booster can be switched on and off automatically through MAXIMATOR air pilot switches, contact gauges or external control devices.

As a result of the wide range of models it is possible to select the optimum gas booster for each application. Single stage, double acting or two stage gas boosters or a combination of these models can be used to achieve different operating pressures and flow capacities.

• Pressure test with gas
• Gas transfer
• Gas recovery
• Charging of nitrogen accumulators
• Supply for isolating gas systems
• Gas assisted injection moulding
• CO2 foaming
• Transfer of oxygen cylinders
• Charging of breathing air bottles
• Leak test